Kitchen Sink Leaking from Drain 5 Min Easy Fix You Can DIY a simple fix save some money on a service call and do it yourself with just an adjustable wrench this is usually caused by a bad seal between the sink and drain
Use an adjustable wrench and disconnect the pipe from the drain and then remove the drain and seal. Then we will clean the sink and seal everything up with plumbers putty and a new drain gasket. You might as well just replace the strainer while you are at it. These are the things you will need:
- Adjustable wrench
- Plumbers Putty
- New rubber drain gasket
- New Strainer (If Replacing)
- Pan To Catch Water
Table of Contents
If You Need To Replace Your Drain Check Out These Products On Amazon
Kitchen Sink Leaking From Drain The Easy 5-Minute Fix
OK let’s do this. The first thing is you want to be able to have access to your kitchen sink drain. So if there are products in the way just move them temporarily so you have unrestricted access to your drain.
Disconnecting the pipe from the kitchen sink drain using adjustable wrench
Most plumbing today is done with PVC pipes which most of the time you can take off by hand. But if by chance your plumbing has not been upgraded this is where you will need your adjustable wrench. Just get it tight around the slip nut and give it twist counter clock wise.
PRO TIP: When Taking this apart keep all the nuts, washers, and gaskets in the order they come off or even better take a picture so you know how to reassemble everything when the time comes
Video Disconnecting The Pipe From The Sink Drain
Remove the Big Locking Nut On The Strainer
Next, you need to remove the locking nut from the strainer. This is a huge nut and what I do is grab a flat head screwdriver and a hammer and hit it on the tabs. You can try your adjustable wrench first. You Can also buy a tool here on Amazon to use. In any case you need to get this off.
Next Clean Off The Old Plumbers Putty From The Sink
The next thing is to grab a piece of paper towel and clean the old plumbers putty off the sink. You can also use a scraper to get the stubborn stuff off. Just don’t scratch it up.
Prepare The New Parts For Install
If you are replacing the whole strainer and I really suggest you do it because it is not very expensive and will avoid problems in the future. If not go to the next section.
Next Open Your Plumbers Putty and Wrap Your Strainer Watch The Video
Reinstall Your Sink Strainer
Now, we are going to reinstall the sink strainer. Place it in the sink and lightly push down to squeeze out just a little plumbers putty. Then go under the sink and place the paper ring first then the rubber ring and slide the bottom of the strainer on. Next, screw on the brass nut and tighten by hand first then use your adjustable wrench to snug it up holding the tail so the strainer doesn’t spin.
Reinstall Your drain Pipe
Next Reinstall your drain pipe making sure you snug up the nuts. Once that is done go back up top and remove any excess plumbers putty and save it for another day. Run the water and check for leaks. Thats it all done.